Home

Topseal Cleaning Procedures

1. Hose off all paving or cement generously, making sure to wet down the surface completely.

2. Apply a chemical mix depending on how dirty the bricks are, making sure not to miss any areas at all.

3. Broom in chemical mix into areas with heavy staining or markings.

4. High pressure clean all paving, repeat chemical mix on areas that are still marked if needed. Making sure to pressure clean it off immediately.

5. Allow no traffic on cleaned area and wait until completely dry before applying sealer.

For any further cleaning information please contact us                        on 9359 0513.

Topseal applied with roller                         & non-slip application

1. The substrate must be completely clean and dry before proceeding. Marks on surface will show through.

2. Do not overfill roller and roll excess from edges of roller to prevent lines of thicker product. Apply a consistent thickness.

3. For first coat, apply in small sections rolling in a north/ south direction.

4. Second coat may be applied as soon as first coat is dry (approximately 1 hour depending on weather conditions).

5. For second coat, apply in small sections rolling in an east/ west direction.

6. Depending on weather conditions the Topseal will be dry enough to take light foot traffic and rain after 4 hours.

7. Do not allow wheeled traffic or storage of any materials on Topseal for 3-4 days, depending on weather conditions.

To achieve a non slip finish with Topseal sealer a light sprinkling of fine washed white quartz sand is applied while the first coat is still damp - second coat is applied over first coat to lock in sand.

Please note

Process can be achieved by using an airless spray gun, with the same procedures applied.